Configuring the Advanced Security Module (ASM)

1. Navigate to Devices.
   
2. Click next to the Schlage RC you want to configure the ASM for, and choose Edit Device Settings from the pop-up menu.
3. Toggle the ASM slider to the on position.
   1. Note: When using an ASM, the Fail Mode must be set to “Fail Secure”
4. Select Save & Continue.
5. Select the desired lock state (once testing is complete) then click Ready.
6. Follow the prompts to configure the ASM.
   1. First, factory reset the ASM by using a pin to hold the reset button down for ~5 seconds (status light will turn green).
   2. Once the ASM has been reset, click Yes.
   3. An admit will be sent as a test:
      1. The reader’s LED should turn green for the duration of the latch interval.
      2. The ASM’s status light should turn green for the duration of the latch interval.
      3. The physical lock should unlatch for the duration of the latch interval.
   4. If the admit test did not successfully unlatch the lock, click No, and then follow the prompts to repeat the configuration process.
   5. If the admit test did successfully unlatch the lock, click Yes.
7. Click Next.
8. Verify the information, and then click “Save*.

!If the ASM’s status light is stuck green, you will need to repeat the configuration process. If the status light turns amber during the admit test, the encrypted ASM code does not currently match what is set in Zentra and the ASM configuration process must be repeated (you may need to factory reset the ASM).