This features programs the credential to act like a ‘Pass Through’ credential. Specifically, it will either bypass a locked down access point, bypass a two-factor rule or provide 24/7 “Always” access to doors where user currently has Grant Access permissions
When a badge is presented it will unlock devices based on the selection below. Choose All Access points, an Access Point Group, or a single Access Point.
Limits the time during which a credential will be active.
The NDE, LE, XE360, and Schlage RC only support credential activation and expiration time resolution down to the hour while the IP-Bridge/MTB and the Control support activation and expiration time down to the minute. This currently will cause Control & the IP Bridge to expire at a different time than the NDE, LE, XE360 and Schlage RC.
For example. If someone set an credential expiration time to 5:16pm, access would actually expire at 5:00pm for NDE, LE, XE360, and RC, while access would expire at 5:16pm on the Control lock (aka resident door) and an MTB+IP-Bridge combo.
Next to the credential you want to add the special property to, click on the Special Properites icon.
Choose the appropriate properties by clicking and then sliding the toggle next to each property you want to enable. All special properties are set to Disabled by default. Some properties will have additional settings. Set each setting appropriately before continuing.
Click Update.
The Special properties updated! screen will display. Click Finish.
The credential update screen will be displayed (if this was a physical credential). Click Update and then present the credential to the reader.
Click next to Special Properties. All the current special properties will be displayed.
Click to toggle the slider under each special property you want to edit.
As you toggle a slider on, some additional dialogues may be displayed. See the following topics for more information.
and then sliding the toggle next to each property you want to enable. All special properties are set to Disabled by default. Some properties will have additional settings. Set each setting appropriately before continuing.
next to the credential you want to edit.
next to Special Properties. All the current special properties will be displayed.
